Hello Guest it is March 29, 2024, 04:55:46 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Ranger

Pages: 1
1
General Mach Discussion / Re: Scaling Problem - Help Needed
« on: December 08, 2009, 04:12:03 PM »
Ok, I will get that information, Thanks for the help

2
General Mach Discussion / Re: Scaling Problem - Help Needed
« on: December 08, 2009, 12:56:06 PM »
We have the XML KX3 profile and have loaded it, but machine still moves not as programed

3
General Mach Discussion / Re: Scaling Problem - Help Needed
« on: December 08, 2009, 07:53:17 AM »
We bought it from a dealer in Maine. We installed it ourself.  It wasn't hard to get it installed. It just seems like the software is not working right.

4
General Mach Discussion / Re: Scaling Problem - Help Needed
« on: December 07, 2009, 04:14:38 PM »
I have the same problem. We just bought a Mach 3 KX3 milling machine. If I program 3.00 in the y, the table moves only .500, same for all three axis. Can you please explain how to fix this. Thanks you

Pages: 1