Messages

1

General Mach Discussion / Re: Font Islands

« on: March 13, 2017, 06:18:43 AM »

Thanks for your reply, yes that is what I had in mind.
I had hoped that there may be a way of doing it  other than Using Cam.
Looks as though I will have to go that route.

Thanks again

Roger

2

General Mach Discussion / Font Islands

« on: March 11, 2017, 01:52:57 PM »

Is there an easy way to leave fonts as islands, similar to making a number plate as found on steam Locomotives?

Roger

3

General Mach Discussion / Re: Latest update problem

« on: June 06, 2011, 05:04:39 PM »

Hi Derek,
Thanks for you reply, I am not sure how to achieve that with Turbocad/cam.
As I said it only occured when I updated to the latest Mach3, it was Ok with Ver. 2.6
I have run the same file on 2.6 no problems.

Regards

Roger

4

General Mach Discussion / Latest update problem

« on: June 06, 2011, 09:56:06 AM »

I have just down loaded and installed  R3.043.022 on win 7 32 bit. I use TurboCAD15 Cad/Cam.
I only use this system to create the original files but use XP on the actual machine output.
The arc locations now seem to be in the wrong place,the linear postions are Ok.
See attached file.The first file I used was more complicated so drew anothersimple  one to prove the point with the same result.
Does anyone have any suggestions please.

Regards

Roger

The second picture is what I expected it to be.