Hello Guest it is April 17, 2021, 11:42:03 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - barkster

Pages: 1
1
General Mach Discussion / Re: Getting My Machine to Move
« on: November 21, 2009, 12:49:13 PM »
Really, why is that?

No the motors make noise.  I got them to move once playing with settings but they sounded bad.  I'll post a video of with mach and with turbocnc

Reset button is not flashing and when it does I just click to turn off.

2
General Mach Discussion / Re: Getting My Machine to Move
« on: November 21, 2009, 12:25:32 PM »
Good catch but unfortunately that was the only one I had reversed.

You have the STEP and DIR pin assignments reversed.

TPI and machine is set to Inch

Here is screeny of my drivertest.exe


I set the steps/in as you said with same results.  I'm wondering if it doesn't like my driver board.



3
General Mach Discussion / Getting My Machine to Move
« on: November 21, 2009, 11:32:32 AM »
I've been running turbocnc for dos for years on my machine, notebook cratered and wanted to go to windows based so I fired up a new workstation with vista and installed turbocnc 5 windows with I think there is a bug preventing different pitch on leadscrews because my two axis that have the same pitch work fine but I cannot get it to move correct distance for my axis with different pitch no matter what I try. The machine moves great and very smooth but can't get my x-axis correct. So, I installed Mach3 and ran registry patch then drivertest, all worked fine and NO BSOD so I continued to configure.  I even tried following step by step of the installatio video.  No matter what I try I cannot get it to move correctly.  I've run into this years ago when I first tried it and just stuck with my dos program but now need to figure out why I cannot make it work.  Here is my setup.

Gecko 201's
250oz stepper motors
y&z axis 14pitch
x axis 13 pitch
1:1 gear ratio

turbocnc screen


I've tried starting with 2000 steps/inch all the way up to 32000 and all kinds of accelleration and velocity



any ideas on how to get me moving correctly. I can get it moving kind of but not correctly and not smooth and of course not in the correct increments

Pages: 1