Hello Guest it is March 28, 2024, 10:02:24 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - gewe

Pages: 1
1
FAQs / Stepping too fast / Motor tuning wrong
« on: November 18, 2009, 03:48:21 AM »
Hi there..
I've just updated from version 3.042.020 to 3.042.32. But now my machine runs 20-30%faster than before which could cause mechanical step loss...
I have already retuned my motor settings. But when I set maximum step velocity to 3000 steps it runs approx. 3900 Steps.
2000 results in 2600.
With the old versions the motor tuning settings were OK.

This happens when jogging around. Also setting speed with the F command results in faster step rates while executing programs...

What is going wrong?

regards
gewe

Pages: 1