Hello Guest it is September 18, 2019, 08:51:10 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jbjackson

Pages: 1
1
General Mach Discussion / Re: Z late getting to final depth
« on: November 20, 2009, 11:05:56 PM »
I did change it from CV mode but cut was real jerky. I've been getting the G codes via Lazycam. Could it be a setting in LC?
Joe

2
General Mach Discussion / Z late getting to final depth
« on: November 20, 2009, 12:01:12 PM »
Hi, Let me start out saying I'm new to Mach. I have just finished building my table and have a problem. Whenever I start to make a cut my Z axis doesn't get to it's final depth before x and y start to move. It will get there, but the first part of the cut is shallow.
Joe

Pages: 1