1
General Mach Discussion / Re: Mach crashes, machine still moving!
« on: November 16, 2009, 01:42:41 AM »
agreed, thanks.
would you also say that switching between tabs within mach is also not recommended? (from the prog. run screen to the MDI or toolpath screen, for example)
One detail I forgot to mention before is that on a couple of occasions the crashes resulted from moving to another screen within mach3.
Thanks,
JEB
would you also say that switching between tabs within mach is also not recommended? (from the prog. run screen to the MDI or toolpath screen, for example)
One detail I forgot to mention before is that on a couple of occasions the crashes resulted from moving to another screen within mach3.
Thanks,
JEB