1
General Mach Discussion / Re: x axis mounted and working, y & z stalling!
« on: February 05, 2007, 04:25:57 AM »
Hey Hood,
By that are you referring to the power feed to the PCI card? If so then there isn't a power cable directly to the card, it gets its power through the connection slot in the mother board. I have noticed that there is power coming down the leed from the parallel port to the machine as some of the LED's in the machine are slightly on even when the machine is off (that probably means nothing!). Should be able to test on another person computer later this week, fingers crossed!
Steve
By that are you referring to the power feed to the PCI card? If so then there isn't a power cable directly to the card, it gets its power through the connection slot in the mother board. I have noticed that there is power coming down the leed from the parallel port to the machine as some of the LED's in the machine are slightly on even when the machine is off (that probably means nothing!). Should be able to test on another person computer later this week, fingers crossed!
Steve