1
General Mach Discussion / Re: EMCO VMC-100 conversion
« on: September 23, 2012, 07:03:47 AM »
Hi DWalsh62,
MACH3 is a worldwide used piece of software and there are tons of online help video and add-on hardware that you can choose from so you can get a optimal setup.
CNC controller like the GSK from chine, has limited online help and almost non online video to help you to it to work.
Even a $1000 does not sound like so much
MACH3 is a worldwide used piece of software and there are tons of online help video and add-on hardware that you can choose from so you can get a optimal setup.
CNC controller like the GSK from chine, has limited online help and almost non online video to help you to it to work.
Even a $1000 does not sound like so much