Hello Guest it is October 15, 2019, 06:28:21 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - sml

Pages: 1 2 3 4 »
1
G-Code, CAD, and CAM discussions / post processor 5 axis
« on: June 04, 2011, 11:09:03 PM »
Hi to all


I need a general(Fanuc,Mach3,...) 5 axis post processor for Powermill software by PMPOTS processor.

Please help me and sent a 5 axis post processor to below Email address :

mctco.uae@gmail.com




Thank you

2
General Mach Discussion / DC spindle motor
« on: May 19, 2011, 07:12:56 PM »
Hi to all

I want use Mach3 for control a cnc machine with below specification :

Spindle : DC motor - permanent magnet - 400 watt  at 3600 rpm - 90 volt - 4 amper.

Axis motor : stepper motor - 5 phase - 10 wire - 16 kgf.cm - 1.4 amper.

What board do you suggest for control this spindle and axis motor? I don't know how can i control the spindle motor?
Can some one help me.
Does any board can control this spindle directly?

Please help me

Thank you

3
Mach SDK plugin questions and answers. / Plug in
« on: August 17, 2010, 03:00:33 AM »
Hi

I have a PCI1240-U Advantech board  but Mr.Hood in mach forum told me that i need to write a plug in for this board but i don't know what is plug in and how can i write it.
I don't have enough information about this board like wiring map or software adjustment.
Can someone help me please.

Thank you
S.M.L

4
General Mach Discussion / Re: PCI-1240U
« on: August 17, 2010, 02:07:59 AM »
ok
Thank you

5
General Mach Discussion / Re: PCI-1240U
« on: August 16, 2010, 02:31:13 PM »
Hi dear Hood
I am new in Mach3 can you help me what is your mean of write a Plug in?
please help me more because i think you only can help me.
Thank you

6
General Mach Discussion / PCI-1240U
« on: August 16, 2010, 08:09:46 AM »
Hi
Is someone know or use PCI-1240U(http://www.advantech.com.tw) board?



Please let me know if some one used this board.
Thank you

7
General Mach Discussion / Re: Spindle
« on: May 09, 2010, 12:13:02 PM »
Hi Rich
I got it
Thank you for your reply

8
General Mach Discussion / Re: Spindle
« on: May 09, 2010, 12:08:01 PM »
Thank you

9
General Mach Discussion / Spindle
« on: May 09, 2010, 06:23:52 AM »
Hi
Can anyone tell me , can i have a spindle pressure sensor for my milling machine by mach3 ?
What instrument i need for this ability on my spindle?
thank you

10
General Mach Discussion / Re: Cutting speed
« on: April 30, 2010, 03:34:21 PM »
Hi Hood
Does the centroid software like mach software for rapid equal with max feed ?

Pages: 1 2 3 4 »