Messages

1

Machscreen Screen Designer / Re: Please help, I can not use system hotkeys when design a new screen

« on: November 26, 2009, 04:28:54 AM »

Thank you, I tried it succeed.

2

General Mach Discussion / Re: How to reload last "Machine coordinate" when start up ?

« on: November 26, 2009, 04:26:09 AM »

Check these items on your CONFIG page.

Dear all,
Mr Overloaded is answered me, that is what I need. Thank all again.

3

General Mach Discussion / How to reload last "Machine coordinate" when start up ?

« on: November 24, 2009, 11:52:02 PM »

Dear all,
I'm investigating mach3
I have a question about Machine coordinates work coodinates

When start mach3, Machine coordinates is automatic set to zero , after that I need REF ALL HOME to find Home position again !
After Run some G code file, I turn off Mach3, at that times it ask me "SAVE FIXTURES?", I answer YES.

When Start up Mach 3 again Machine Coordinates is become ZERO.

--> My question : how can I set to Mach3 to make it start up with the last Machines coordinates instate of  Zero .
Sorry about my English.
 

4

Machscreen Screen Designer / Please help, I can not use system hotkeys when design a new screen

« on: November 24, 2009, 11:20:28 PM »

Dear all,
I use Mach3screen to design a new screen set, but I can not use any system hotkeys to move one axis

when I assign "right arrow key " to increase X
                      "left arrow key" to decrease X


When I load my own .set, I cannot use those hot key, when I press "right arrow" or "left arrow", X value does not change.
 But if I load 1024.set or plasma.set (default in Mach3 folder) every thing is OK.
(I also add a button to enable or disable Jog mode, and a reset button.)

Sorry because my English is not good.
I attache my test.set
and my nrw.xml
please help me.