Messages

1

General Mach Discussion / Re: Alphacam

« on: February 04, 2010, 03:24:25 PM »

Thank you very much
I wiil see that...and you can see my site
 www.artecnc.com.ar...and now I began to do some parts for rc model cars.
Best regards
Antonio

2

General Mach Discussion / Alphacam

« on: February 04, 2010, 10:56:44 AM »

Hi
I read that I can use Fanuc post, when y load the file in the Mach3, dont see a toolpath¿?...is that correct? I´m used to Syil 4Plus Mill.
Thank in advance
Antonio