1
General Mach Discussion / mach pausing during cutting
« on: October 17, 2009, 10:16:23 PM »
Hi
Ive got a small problem.
towards the end of the cut (same point every time) the steppers must pause for some reason?
but mach must still thinks its moving, ive tried it on a different driver so it definitely a software problem,
the gcode comes from cambam
thanks
Ive got a small problem.
towards the end of the cut (same point every time) the steppers must pause for some reason?
but mach must still thinks its moving, ive tried it on a different driver so it definitely a software problem,
the gcode comes from cambam
thanks