1
General Mach Discussion / Re: second parallel port on MACH3
« on: October 13, 2009, 11:35:51 AM »
testing device: from 5Volt a resistor of 300 ohms to the input pinand then with a switch to ground. For verifying the Testdevice I used in on a freeware software for the parallel port. It is working very well.
Sorry for the pins 14 16 and 17. You are right. Of course I tested the Parallel port as it is described in chapter 4.4.1 in the Mach 3 manual.
Belive me: I verified all possibilities more then one time.
Thank You and Ciao
Sorry for the pins 14 16 and 17. You are right. Of course I tested the Parallel port as it is described in chapter 4.4.1 in the Mach 3 manual.
Belive me: I verified all possibilities more then one time.
Thank You and Ciao