Hello Guest it is March 29, 2024, 04:35:12 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Maniac

Pages: 1
1
General Mach Discussion / VB macro & shuttle.
« on: September 30, 2009, 03:55:22 AM »
Hello everyone

I am moving the lathe in using MACH3.
This is a question of the VBmacro & shuttle.


I want to make the chamfering of the lathe in using the jog dial of the shuttle.
How can I move the tool by VBMacro ,for direction 45degrees by synchronizing with the jog dial?


2
General Mach Discussion / Re: for using 'CustomMacro1~10'
« on: September 30, 2009, 03:36:18 AM »
Hi !  Ray L.

It went well. Thank you.

3
General Mach Discussion / Re: for using 'CustomMacro1~10'
« on: September 30, 2009, 02:32:42 AM »
Thank you for a prompt explanation.

Was it M code number?
I will try it.

4
General Mach Discussion / for using 'CustomMacro1~10'
« on: September 29, 2009, 08:34:09 PM »
Hello everyone!

Please teach the method of using'CustomMacro1~10'.

What kind of number should be written on the 'CustomMacro1'BOX of Dialog on config shuttle.


Pages: 1