1
General Mach Discussion / Re: CNC or Mach3 calibration issue?
« on: October 17, 2009, 07:39:37 PM »
Hi Rich,
Yes that was something i was thinking that it could be in the pulleys...i did following test:
X + 500 =499.65 (i then zero'd the scale)
X - 500 = -499.63
X + 500 = 499.57
X - 500 = -499.61
X + 500 = 499.65
X - 500 = 499.62
X - 500 = 499.54
I also tried adding backlash (although i'm not very familiar with this setting)
same as above moving forward 500, zero the scale, then back 500
backlash .05 @ 20% speed
499.84
-499.63
499.58
-499.59
499.59
-499.61
Not sure if the above makes sense or if that indicates a backlash issue as the figures are still inconsistent?
Cheers
Glenn
Yes that was something i was thinking that it could be in the pulleys...i did following test:
X + 500 =499.65 (i then zero'd the scale)
X - 500 = -499.63
X + 500 = 499.57
X - 500 = -499.61
X + 500 = 499.65
X - 500 = 499.62
X - 500 = 499.54
I also tried adding backlash (although i'm not very familiar with this setting)
same as above moving forward 500, zero the scale, then back 500
backlash .05 @ 20% speed
499.84
-499.63
499.58
-499.59
499.59
-499.61
Not sure if the above makes sense or if that indicates a backlash issue as the figures are still inconsistent?
Cheers
Glenn