Hello Guest it is July 27, 2021, 04:02:11 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - cmcmanager

Pages: 1
1
General Mach Discussion / Re: Homing Trouble KX1
« on: May 02, 2010, 02:26:43 PM »
Ok , I've to explain you again:

Our machine was worked for long time with any problem.

But 3 days a go this problem was happened:
When the cnc machine complete the hacking work, automatically traveling to home (the gcode line number is final line & the gcode traveling position is x=0/y=0/z=0).
Hence, x & y axes travleing to "0" position but z axes crossing the "0" position and hits the table.for example the position of z at this time is "-50" but It should be "0" position.
And finally the counter display of mach3 showing{ x = 0,y = 0,z = -50}!!

2
General Mach Discussion / Re: Homing Trouble KX1
« on: May 02, 2010, 05:05:32 AM »
Dera Hood,

Thanks for your reply,

I don't understand losing steps in z axes!please guide me further If possible.
Why does  when machine is duration of work we don't have any losing step!!?
And I think we don't have any roughness or binding.

I'll wait for your early reply.






3
General Mach Discussion / Re: Homing Trouble KX1
« on: May 02, 2010, 01:29:47 AM »
Hi all!

When our cnc machine automatically traveling to home position(after end of gcode work ),the x & Y axis is properly stop at 0,0 position but the z axes hits the work table at (-50) position(for example). Please Help me!

Thanks,
mostafa

4
General Mach Discussion / resume the gcode
« on: December 02, 2009, 10:06:04 AM »
Hi all!

Can you tell me about the resume of  last situation of g-code ,after user close the mach3 ?
By the way when we need to work off ,how can we  save the current gcode so user resume it(the next line of gcode) at last day!?

thanks.
mostafa

Pages: 1