Messages

1

LazyCam (Beta) / Re: Pro Demo.No GCode

« on: September 21, 2009, 06:20:55 AM »

Dang. Thanks Rich.

2

LazyCam (Beta) / Pro Demo.No GCode

« on: September 20, 2009, 10:24:32 PM »

What is this? I can't make any pockets. I'm lost....

3

General Mach Discussion / Re: How do I set motor gearing?

« on: September 19, 2009, 12:08:17 PM »

Cool! Thanks buddy, I will mess with it now 

4

General Mach Discussion / How do I set motor gearing?

« on: September 18, 2009, 10:32:07 PM »

First post 


I finally got my CNC ready for use! The only thing holding me back is getting the gearing fro the stepper motor to the mach3 correct. When I run the roadrunner program the program is aobut as big as my whole table when cutting! 3ftx3ft

can anyone inform me or point me to a link I'm not seeing? I watched the tutorial videos, and I hope I didnt look over this step