Hello Guest it is March 29, 2024, 08:34:31 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - adi

Pages: 1
1
General Mach Discussion / Re: MACH3 is reassigning motor pins by himself
« on: September 06, 2009, 05:19:00 PM »
I just installed it on another computer and it has the same problem.

2
General Mach Discussion / Re: MACH3 is reassigning motor pins by himself
« on: September 06, 2009, 05:17:30 PM »
Is it possible that my licence - being very old - could not work for MACH3 ?

3
General Mach Discussion / Re: MACH3 is reassigning motor pins by himself
« on: September 06, 2009, 04:55:56 PM »
Thank you HimyKabibble for the answer.

The PC is a Pentium 4 / 3GHz, 1 G RAM, I don't think this is the problem.
I run on it without any problem MACH2.
I tryed Making the .XML read-only, it didn't solved the problem. Now it happened at 5000 lines.
Probably the program loads it at the start, and after that it can change it.

It is not "a crack version" Manmardam.
I just downloaded it from artofcnc.ca version 3.042.029, with the old licence that I used with MACH2

4
General Mach Discussion / Re: MACH3 is reassigning motor pins by himself
« on: September 06, 2009, 04:35:56 PM »
Thank you for answering.

I tryed several times this routine, with saving, exiting, reinstalling,
I even tryed to install older versions of MACH3, it has no effect.
After around 8000 lines it looses the pin assignment.
I thought that others may have encountered the same problem and solved it.

5
General Mach Discussion / MACH3 is reassigning motor pins by himself
« on: September 06, 2009, 03:11:35 PM »
I have a problem with MACH3:
After a number of lines of code the movement on x axis stops, after a while another axis stops..
When I check it in the Ports&Pins / Motor Outputs, the assignments of the step/direction
pins are changed to 0, or between them.
Please help.

Pages: 1