Messages

1

General Mach Discussion / Re: history errors

« on: September 01, 2009, 04:13:25 PM »

Ger21 thanks I changed the setting of the iJ mode and it works great  your a life saver

thanks again

2

General Mach Discussion / Re: history errors

« on: August 31, 2009, 11:02:54 PM »

thanks ger21 I'll give it a try tomorrow 

3

General Mach Discussion / history errors

« on: August 31, 2009, 09:37:35 PM »

 I keep getting an error that says    "  Radius to end of arc differs from radius to start of line "
I'm using vectrics Aspire and Vectrics pro 6 and both get the same error is there a setting in Mach 2/3 that might have got changed ?