3
« on: August 18, 2009, 06:45:48 AM »
Daniel,
I have looked at the manual on the SGDA-04AP and the SGDA-04AS. One is a position control (Step and direction) and one is (Speed and velocity). It seems that the 04AP would work but I have read so many negative post on CNC Zone about using this one. Nobody can agree to use or not to use on there. They say that it needs to have a converter board from pulse to +/- 10 VDC signal. I really want to use Mach 3 and don't know what type of interface/breakout board will work with the drives. I thaough that someone may have used these before and could give me advice before I go to far with the project. Thanks for your response.
William