Messages

1

Share Your GCode / DXF Crab

« on: March 25, 2015, 08:05:36 PM »

Here's a crab I drew to cut out on my plasma cutter.

2

Building or Buying a Wood routing table.. Beginnners guide.. / Re: Stepper motor ID

« on: January 20, 2014, 06:17:01 PM »

Thanks!!!!

3

Building or Buying a Wood routing table.. Beginnners guide.. / Stepper motor ID

« on: January 19, 2014, 07:03:31 PM »

Can anyone tell me the specs on this motor 60HS100DE06

When this motor is at rest it has a hissing noise runs fine without a problems is this something I should be concerned about?

Thanks
Bill............

4

General Mach Discussion / Re: Losing Z Height in Mid Operation

« on: November 02, 2013, 07:50:13 PM »

did you replace it with a larger one?

5

General Mach Discussion / Re: Losing Z Height in Mid Operation

« on: November 02, 2013, 05:39:06 PM »

I have a small American made router and have had the same problem it would lose the steps when the code asked it to raise the Z rapidly with the G0 code. So I changed all the G0 to G1 and a feed rate less than full speed and it works fine. I had this unit for several years and did not have or notice a problem till I started doing some 3d relief stuff moving the Z axis a lot and fast.
No expert by any means still learning hope this will help.
Bill.....

6

Show"N"Tell ( What you have made with your CNC machine.) / Re: FIRST TIME 3d relief

« on: July 26, 2013, 07:27:04 PM »

Thanks Guys i think they are just what i'm looking for.

7

Show"N"Tell ( What you have made with your CNC machine.) / FIRST TIME 3d relief

« on: July 25, 2013, 04:32:37 PM »

I purchased this STL file off line and asked for the gcode and gave it a try. I was very happy with the results. The code came in 2 files one rough cut and one finish that word great for my small roto zip machine. I am looking for a STL or gcode for a set of praying hands if anyone could help me out.

Thanks
Bill.............

8

Share Your GCode / trailer gcode

« on: July 23, 2013, 10:38:51 PM »

Here are some gcode's i put together for some friends camping trailer. I engraved thier names and state in the bottom section.

I am looking for a stl file or gcode for a set an praying hands around 3" tall

Thanks
Bill.....................

9

Share Your GCode / Re: G code needed

« on: October 17, 2009, 10:35:08 AM »

Here it is in jpeg so you view it.

10

Share Your GCode / Re: G code needed

« on: October 17, 2009, 10:32:31 AM »

Here is the 5th wheel sign I made Thanks again for the fire truck.