Messages

1

General Mach Discussion / Re: "run from here" problem

« on: April 23, 2014, 09:16:34 PM »

Sounds like I am SOL on long runs.

2

General Mach Discussion / Re: "run from here" problem

« on: April 21, 2014, 07:26:44 PM »

Weird. Maybe it is a setting that I have wrong in my sheetcam setup. Do you have a gcode file I can try? I would like to try one that I did not create. Thank you for helping me with this.

3

General Mach Discussion / Re: "run from here" problem

« on: April 19, 2014, 10:59:36 AM »

I copied it

4

General Mach Discussion / Re: "run from here" problem

« on: April 19, 2014, 09:44:46 AM »

okay sorry. I went back a tried to attach the xml but it won't let me since I posted the same name xml further back in the thread.

5

General Mach Discussion / Re: "run from here" problem

« on: April 18, 2014, 08:15:15 PM »

Here is the file

6

General Mach Discussion / Re: "run from here" problem

« on: April 17, 2014, 05:38:05 PM »

Hey Guys, I am back two years later and still cannot get the RFH function to work. Its still reverting back to line 12 on all my gcode when I hit the RFH button. I have tried the settings last mentioned and nothing changes. Any more ideas?

7

General Mach Discussion / Re: "run from here" problem

« on: January 08, 2012, 08:08:05 PM »

Yes Sheetcam TNG

8

General Mach Discussion / Re: "run from here" problem

« on: January 08, 2012, 07:36:29 PM »

yep line 12 for me. I am way more clueless than you I am sure. I used sheetcam to create the code if that helps.

Hey Zealous, I tried that and still no go. Should I restart mach?

9

General Mach Discussion / Re: "run from here" problem

« on: January 08, 2012, 07:20:39 PM »

Here is the file I was running today.

10

General Mach Discussion / Re: "run from here" problem

« on: January 08, 2012, 07:09:32 PM »

I have parallel ports 1 and 2 for the THC300.

I unplugged the keyboard and tried to scroll but no go. I also switched the screens to plasma.