Hello Guest it is November 27, 2021, 04:37:50 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - mma

Pages: 1
1
General Mach Discussion / Re: Gets ERROR G100 not communicating
« on: July 30, 2009, 03:14:47 PM »
pls help on this!!Very urgent..

Thanks
Mohammad

2
General Mach Discussion / Re: Gets ERROR G100 not communicating
« on: July 30, 2009, 02:47:26 PM »
I installed the newer VErsion 1.0.0.1 after the previous Ver R1.84.002 crashed.. Now, while trying to run it it gives me msg " G100 not communicating"..
Error during Run Phase: Comm/Prog Error
Master Partition: inst=0 part=0 ecode=777
connection lost..

also, I cant select/deselect in G100 Monitoring under Plugin Control..

No movement of the machine at all with the arrow keys in the key board..

Pls help'

3
General Mach Discussion / Gets ERROR G100 not communicating
« on: July 30, 2009, 02:46:01 PM »
I installed the newer VErsion 1.0.0.1 after the previous Ver R1.84.002 crashed.. Now, while trying to run it it gives me msg " G100 not communicating"..
Error during Run Phase: Comm/Prog Error
Master Partition: inst=0 part=0 ecode=777
connection lost..

also, I cant select/deselect in G100 Monitoring under Plugin Control..

No movement of the machine at all with the arrow keys in the key board..

Pls help'


Pages: 1