Hello Guest it is January 24, 2020, 08:21:22 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - birlan

Pages: 1
1
General Mach Discussion / Re: mach3 motor configuration
« on: July 30, 2009, 03:04:36 PM »
After fresh reinstall with (Standard PC) option  - everithing is working now !
Thank you all !

2
General Mach Discussion / Re: mach3 motor configuration
« on: July 30, 2009, 08:01:58 AM »
Please attach your xml.
Hood

I reinstal the sistem now and choose the Standard PC - I dont have any file left on it !
But What xml do you need ?


3
General Mach Discussion / Re: mach3 motor configuration
« on: July 30, 2009, 07:15:19 AM »
I don't have any printer install or any other drivers except via4in1.
It's xp+sp3 + updates - fresh installed last night. After reboot it work fine for about 8-10 seconds, and then loose step, anoying comportament of the motor (when I move the mouse, the motors take speed).
should I uninstall sp3 ?
I don't find in bios any ACPI (enable/disable), I have disabled Com ports, Paralel port change to ECP, load fail safe bios defaults, without any luck !
What drivers should I uninstall ?


4
General Mach Discussion / Re: mach3 motor configuration
« on: July 30, 2009, 03:04:40 AM »
It work fine , but I have to move the mouse. When the mouse is still (mouse pointer don't move on the scree, I don't touch the mouse , the motor not working well - lot of vibration, low speed loose steps etc...). All I have to do is movind the mouse and work fine .

Could anyone help me ?

PS: I have AMD 2800+ 1GB RAM, Optical mouse , winxp (updated) - fresh install.

5
General Mach Discussion / Re: mach3 motor configuration
« on: July 29, 2009, 07:56:50 PM »
The drivers are made with A3977 and they have 2 jumpers for step configuration , full step, half step, quarter step and eigth step

6
General Mach Discussion / Re: mach3 motor configuration
« on: July 29, 2009, 07:39:36 PM »
Hi,

Pitch screw = 2mm
Bipolar 200 step motor
Gear ratio = 2:1 (screw gear : motor gear)
Metric

7
General Mach Discussion / mach3 motor configuration
« on: July 29, 2009, 06:02:18 PM »
Hello,

I have 200 step motor and I cannot setup motor turning smoothly.
Could anyone can help me to fill boxes from "Motor turning and setup" window !

Any help will be appreciated !

Birlan

Pages: 1