1
General Mach Discussion / Re: Mill x,y distortion problem Need Help
« on: July 27, 2009, 05:56:41 PM »
Thanks everyone for your help. I am not sure what the issue was but I reloaded the XML from soundlogix on my MachIII and now I am getting better results. I still have ~.008 oval but this is most likely from the backlash or fine tuning the motors. At lest the .040-.050 distortion appears to be gone. I am in the process of ordering some ball screw kits. Hopefully this will get me the .001 accuracy I desire.
Any thoughts on the best ball screw kit to $ ratio available?
Any thoughts on the best ball screw kit to $ ratio available?