Messages

1

General Mach Discussion / Re: Tool offset missed

« on: November 02, 2009, 03:03:15 AM »

Do you have a G43 in your g-code file?

Graham

Hello Graham,

Up to know, I do not have G43 in my part program...
Maybe I would have to ??
I will add and give feed back soon.

Thanks for your help; William.

2

General Mach Discussion / Tool offset missed

« on: October 31, 2009, 06:11:28 AM »

Hello all,

I meet a trouble with Mach 3 Version 3.
When I start operating (auto mode), the tool offset compensation isn't took into consideration. That means the green light which indicate that tool offset is "ON" immediately turns "OFF" while I key "START".
I do not meet such issue with old version...

May somebody can help me ?
Thanks very much in advance.

William.