Hello Guest it is March 28, 2024, 09:10:30 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Dantomkia

Pages: 1
1
Oh Rich, you will never make a marriage guidence councillor. However, you do speak the truth.

My names Mike. I served my engineering apprentiship and ended up being a turner. Hated that coz I wanted to be a miller so I left and went into electronics and computers.

Served adult university for electronics and now work doing HUGE video walls. Got back into engineering a few years ago, purchased a working Bridgeport Interact 1A. Blew that up after a year or so. Its supprising how much smoke you can get out of those seimans servo boards isnt it?

Decided that a complete update / upgrade was required. So, Gecko G100, Mach3 and a host of other bits and bobs later I have a nearly complete and working mill.

One question, Machropumps. I need one that reads a load of inputs from the G100 ( MPG with knobs and buttons ) and sets the required bits in Mach3. Also, FRO. Any one have any basic macros that I can look at?

Cheers and appreciated.

Mike.

Pages: 1