Hello Guest it is June 24, 2021, 02:37:49 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Dr101

Pages: 1
1
Spanish / Re: es que nadie que use mach habla Castellano???
« on: February 21, 2011, 11:19:52 AM »
Holas tambien estoy en bogota y estoy acabando mi fresadora 1.00 x .70
seria interesante  establecer contacto

Dr101

2
General Mach Discussion / Re: No Pulse Frequency!
« on: June 30, 2009, 12:50:56 PM »
I've been building  a DMF router since  Feb 2009 and now its in  my studio expecting to be  fired  up.  but a few  issues  evolve as I work on Mach3 set up . First   I need to figure out why the pulse frequency  has change from a running condition  at 24800 ish   to zero and I cant get it to flow again  I must say that I began to configure the  cnc  with  my ports hooked to the c10 bidirectional breakout board. After having no  motor response I decided to install  the mach pulsing engines using the device manager.  Since then the pulse frequency is dead. I have unhook the board from the PC, uninstall the drivers, reset, reboot,  and tried to run the test again. A message  stating  that a the driver test fails because it  "could not locate missing vector"  shows . What  to do next? Anybody has an idea?

Pages: 1