Messages

1

General Mach Discussion / Newbie: Tool Diameter in Mach problems.

« on: July 13, 2009, 07:58:32 AM »

I am probably doing something wrong but I have set up tool 1 in Mach3 Mill to have a diameter of 3mm in the tool table but it still cuts as though it has a diamter of zero mm.
Any suggestions?

2

VB and the development of wizards / Re: Teach wizard - its gone

« on: June 28, 2009, 04:47:39 AM »

Thanks for that but I cant find the download area on your website for CopyCat V1.1.
Also i have purchased licenses to both mach3 & LazyCam but the wizards still need a license. Is there something wrong with my setup or do i have to purchase another license?
Rod

3

VB and the development of wizards / Re: Teach wizard - its gone

« on: June 27, 2009, 12:59:17 PM »

Found it. It is now called CopyCat Thanks!

4

VB and the development of wizards / Re: Teach wizard - its gone

« on: June 27, 2009, 12:56:55 PM »

Thanks for your reply.
The version I have downloaded is
Version R3.042.020

5

VB and the development of wizards / Teach wizard - its gone

« on: June 27, 2009, 07:41:26 AM »

I have just downloaded the latest version of Mach3 and the two tech wizard are no longer included.
Does anybody know of any thirdparty software or any other solution for "teach"

Rod