Hello Guest it is November 29, 2021, 12:30:39 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Flyrobby

Pages: 1 2 »
1
General Mach Discussion / Re: Tool location in toolpath
« on: February 12, 2012, 10:11:10 AM »
Thanks Hood, I have been messing around with my 4 th axis recently. I really appreciate your help and thanks for your patience.

2
General Mach Discussion / Re: Tool location in toolpath
« on: February 11, 2012, 08:48:37 PM »
Thanks overloaded. Hope this is what you needed Hood. Thanks

3
General Mach Discussion / Re: Tool location in toolpath
« on: February 11, 2012, 08:27:09 PM »
I tried renaming the files but I keep getting this message, what do I need to do? Sorry! There is already an attachment with the same filename as the one you tried to upload. Please rename the file and try again

4
General Mach Discussion / Re: Tool location in toolpath
« on: February 11, 2012, 07:20:22 PM »
That did NOT fix my issue, I do have the latest ver, I know it used to work, did I turn this off somehow??

5
General Mach Discussion / Re: saving setup
« on: February 09, 2012, 06:33:49 PM »
That will help but I updated to the newest version and now I have 2 different versions on my desktop, how do I get the settings from the old one into the new one? am I just deleting these same files in the new version and replacing them with the ones I copied from the older version?

6
General Mach Discussion / saving setup
« on: February 08, 2012, 11:16:03 PM »
Just downloaded the new version of Mach, how do I save my old setup (ports and pins, motor tuning info) and move it to the newer version?
Thanks in advance for any help

7
General Mach Discussion / Re: Tool location in toolpath
« on: February 08, 2012, 11:11:29 PM »
New version fixed it.

8
General Mach Discussion / Re: Tool location in toolpath
« on: February 08, 2012, 06:14:06 PM »
After I posted this I asked myself the same question and I AM do for an update, if the problem perstis after that I'll be back.
Sorry ftom not the same problem.

9
General Mach Discussion / Tool location in toolpath
« on: February 07, 2012, 11:08:05 PM »
When scrolling through the gcode I no longer see the location of the tool in the toolpath screen (or the part of the toolpath that represents the gcode doesn't light up) like I used too, I don't see where that can be turned on or off, do I need to reinstall Mach???

10
General Mach Discussion / Re: missed steps on Y axis
« on: July 23, 2011, 10:03:01 PM »
It was working perfect until I turned on the power to the spindle, I shut everthing off and started over, again perfect until I powered up the spindle. I have it set up so Mach can control the spindle but am not using it now (just using the manual control), I will take a close look at that wiring since I did make quite of few changes by adding some relays and wiring, maybe I built in a ground loop, will have to read up on that.

Pages: 1 2 »