Messages

1

General Mach Discussion / Re: A Axis Setting rotary motion

« on: April 21, 2010, 08:58:23 AM »

Hood,

Would there be  mach1lic.dat  even with Tormach's modified Mach that Jorg could use in the real Mach3?

Jay

2

General Mach Discussion / Re: Setting up a 4th axis (A)

« on: April 19, 2010, 09:40:09 AM »

While on this subject is there a way to disable the Z axis  when you do a GOTO ZERO.   With zero set at the center of my chuck, if theres a work peice in there its goin to drive my bit right through it?

3

General Mach Discussion / Re: A Axis Setting rotary motion

« on: April 16, 2010, 07:46:10 PM »

Hi Jorg,

Tormac seen fit to remove that menu item because it doesn't pertain to your system.  It is problem still in the program some where but I dint where to get access to it.  Like Hood said, call Tormac.

Jay

4

General Mach Discussion / Re: A Axis Setting rotary motion

« on: April 16, 2010, 02:41:12 PM »

Hi Jorg,
Its in the CONFIG tab 4th selection down.

jay

5

General Mach Discussion / Re: Spindle wont start on first run

« on: March 17, 2010, 09:21:08 PM »

Thanks Gerry, I will give it try.

Jay

6

General Mach Discussion / Re: Spindle wont start on first run

« on: March 17, 2010, 08:40:16 PM »

I was just out to the shop and the darn thing was doing OK.  Restarted everything and again OK.  I dont know, the port may very well be the problem.  If it starts acting up again I will swap it to port 2 and see then.  Thanks for all your help.

Jay

7

General Mach Discussion / Re: Spindle wont start on first run

« on: March 17, 2010, 06:57:48 PM »

Thanks for your help, I'll do a bit more looking myself as well. 


Jay

8

General Mach Discussion / Re: Spindle wont start on first run

« on: March 17, 2010, 06:02:24 PM »

Here you go hood, thanks
Jay

9

General Mach Discussion / Re: Spindle wont start on first run

« on: March 17, 2010, 04:19:03 PM »

didnt seem to work, cant seem to upload xml, site says theres already a file by that name Ill get to though
jay

10

General Mach Discussion / Re: Spindle wont start on first run

« on: March 17, 2010, 03:42:41 PM »

I did as you asked, same thing.  The LED shows the router on so Mach thinks its on but it didnt turn on the relay.

Jay