Guest
Show Posts
1
General Mach Discussion / Mach3 Installation Woes in Windows XP
« on: May 03, 2009, 06:56:16 PM »
I just downloaded and installed Mach3 on a Windows XP platform and I am having trouble getting my motors on my Probotix mill to work correctly. I set up the motors according to the video tutorial.
x = Pin 2 and 3
y= Pin 4 and 5
z= Pin 6 and 7
a= Pin 8 and 9
The Y and Z axes work perfectly, the x axis just sits there.
In the diagnostic tab pins 5-9 are lit up.
How do I get pins 2 and 3 activiated? Is that my problem?
Any suggestions would be greatly appreciated.
x = Pin 2 and 3
y= Pin 4 and 5
z= Pin 6 and 7
a= Pin 8 and 9
The Y and Z axes work perfectly, the x axis just sits there.
In the diagnostic tab pins 5-9 are lit up.
How do I get pins 2 and 3 activiated? Is that my problem?
Any suggestions would be greatly appreciated.