Hello Guest it is March 28, 2024, 07:06:53 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jsolano

Pages: 1
1
General Mach Discussion / Re: No Motor movement with Townlabs TL518er
« on: March 29, 2017, 12:31:00 PM »
Hi you helped me years ago. maybe you could help me again. I have a new computer. desktop running windows 7. Again the motors will not turn. there is no value in the Time in box. I checked the port drivers and the computer says I'm running the best. I tried the driver test but it gives me a no driver sensed alarm. the special driver from mach3 says it didn't run right? should i switch back to XP?

2
General Mach Discussion / Re: No Motor movement with Townlabs TL518er
« on: April 29, 2009, 06:10:55 PM »
Thanks for all the help.
Jessie.

3
General Mach Discussion / Re: No Motor movement with Townlabs TL518er
« on: April 29, 2009, 04:10:01 PM »
Okay The driver test. The green bar goes to the middle and the mesage says system excellent. I think its a go.

4
General Mach Discussion / Re: No Motor movement with Townlabs TL518er
« on: April 29, 2009, 03:45:54 PM »
It works!!! I just reinstalled everything and restarted it and it works.I did notice mach loading a port driver . Something I don't remember it doing the first time. Now, will the driver test tell me anything I need to know? Or can go foward into the next round of trouble. Thanks for your help again, Hood.

5
General Mach Discussion / Re: No Motor movement with Townlabs TL518er
« on: April 29, 2009, 11:35:20 AM »
Not sure what I did but my computer woud crash anytime i loaded mach. I reinstalled windows, mach and my configuration file. Now I get a value around 4 for the Time in int. and 25388 value for pulse frequency. Still no movement. I saw a driver test in the mach folder , Would this help? Does mach work with laptops? Thanks, Jessie

6
General Mach Discussion / Re: No Motor movement with Townlabs TL518er
« on: April 28, 2009, 06:38:59 PM »
I try updating the driver for the parell port and it says no better updates, The value is at 0.0 for the time in int box and i don't see were a value for the pulse generater box is. Later I can try this with ny desk top computer. THANKS.

7
General Mach Discussion / Re: No Motor movement with Townlabs TL518er
« on: April 28, 2009, 09:55:13 AM »
 Hello there,Thanks for a quick response. I do have an appointment in a hour but will be back in about 5.my computer has a parallel port ( printer prt right?).I resatarted my computer many times after installing mach and the configuration file. My computer is a  Compac Presario2100 laptop. It says the LPT1 port is working . Altough it does give 2 I/O ranges with 2 different settings.All the settings match the pages in my instruction book. I attached the configuration file and my instruction file. Do you also have a townlabs? Any Suggestons? Thanks again,Jessie
 

8
General Mach Discussion / No Motor movement with Townlabs TL518er
« on: April 27, 2009, 09:25:07 PM »
Hello I am a newbie. Any help will be greatly appreciated. :) I have loaded the demo of Mach 3 and my machine builders configuration file. When I load mach I get  message at the bottom " No shuttle detected of type selected" Any ideas? Thanks

Pages: 1