Messages

1

General Mach Discussion / Re: DRO setting

« on: February 15, 2015, 02:02:53 PM »

Thank you
Had all these settings for a long time and now doing a fresh new setup and can't remember each one and not having luck on search

2

General Mach Discussion / DRO setting

« on: February 15, 2015, 10:57:05 AM »

Where do I click to make Mach3 keep the DRO settings? I shut mach3 and the DRO settings are not the same when I open. I usually have everything where I want zero or 1 inch offset from zer but when I open they seem to show some random set of numbers....

thanks

3

General Mach Discussion / Re: mach3 windows 8.1 32bit install - blue screen

« on: January 25, 2015, 01:03:15 PM »

If the UC100 will work on 8.1 with Mach3 that is acceptable to me. Cool

4

General Mach Discussion / Re: mach3 windows 8.1 32bit install - blue screen

« on: January 25, 2015, 11:58:47 AM »

What is the latest version it does work with?

5

General Mach Discussion / Re: mach3 windows 8.1 32bit install - blue screen

« on: January 25, 2015, 11:09:38 AM »

Under Windows 7 32 bit on same computer this used to work.

6

General Mach Discussion / Re: mach3 windows 8.1 32bit install - blue screen

« on: January 25, 2015, 11:09:20 AM »

Everything now just comes down to the driver for the LPT port.... Software is installed but the driver test says no driver detected.

7

General Mach Discussion / mach3 windows 8.1 32bit install - blue screen

« on: January 25, 2015, 09:47:49 AM »

New installation of Mach3 on a newly installed Windows 8.1 32 bit computer.

I lost my Windows 7 disk and ordered an 8.1 disk. Did a fresh install and then installed Mach3 latest download. Then got blue screen of death and had to use last known good configuration to get the system to boot again.

Any help would be appreciated.
Thanks
Keith

8

General Mach Discussion / Re: motor noise

« on: March 31, 2013, 06:09:56 PM »

You were correct again Hood. I wired the motors incorrectly. THANK YOU!@

9

General Mach Discussion / Re: motor noise

« on: March 31, 2013, 05:29:51 PM »

Thanks Hood -
Unsure hardware wise - where to start.

10

General Mach Discussion / Re: motor noise

« on: March 31, 2013, 10:16:47 AM »

This is a new hardware installation
I might remove all the software and start again. Just wanting an XML file with all default settings without losing anything specific to smooth stepper.
Thanks