1
General Mach Discussion / Re: router tips burning
« on: December 11, 2009, 03:45:15 AM »
An up date on my router bit/tip burning
I cannot seems to get my feeds up past 430 mm per min
computer is a 2.8gig
2 gig ram
and a 8400 giga bite video card with 512 ram on that
steps set to 1-1 my motors are 1:1 to screw 1.25mm per turn
so this is 160 steps for 1 mil ,This I have set up
power supply is a x radio work shop power supply 12 24 volt at 30/40qmp max
I run on 24 volts
Have used Aerospace Tb_axis HY-TB4DV-N controler
and the 3 axis micro stepper motor controler by Mechatronics
stepper motors are 1.8Nm/2490zin
1.8 deg /200 from cnc machinery
4 leads wiring
thanks for help roly
I cannot seems to get my feeds up past 430 mm per min
computer is a 2.8gig
2 gig ram
and a 8400 giga bite video card with 512 ram on that
steps set to 1-1 my motors are 1:1 to screw 1.25mm per turn
so this is 160 steps for 1 mil ,This I have set up
power supply is a x radio work shop power supply 12 24 volt at 30/40qmp max
I run on 24 volts
Have used Aerospace Tb_axis HY-TB4DV-N controler
and the 3 axis micro stepper motor controler by Mechatronics
stepper motors are 1.8Nm/2490zin
1.8 deg /200 from cnc machinery
4 leads wiring
thanks for help roly