Hello Guest it is October 02, 2023, 07:44:44 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - bbrown2005

Pages: 1 2 »
General Mach Discussion / Re: mach 3 plasma
« on: May 17, 2009, 09:11:44 PM »
thanks. i am new with the mach plasma i have been working on my table for about 2 years and excited to have it going thanks, ben

General Mach Discussion / Re: mach 3 plasma
« on: May 15, 2009, 07:52:43 PM »
thanks i did not want to sound stupid for asking but that works great because i have turbo cad v10 also thanks

General Mach Discussion / mach 3 plasma
« on: May 13, 2009, 08:47:09 PM »
hi, i was wondering  how do you set the width of the kerf cut is there a setting for that or do i have to compensate for that each cut

General Mach Discussion / Re: edge finder
« on: February 17, 2009, 08:02:05 PM »
how is yours set up? do you have it as a probe on inputs and do you have any extra plugin beside just mach 3? thanks

General Mach Discussion / edge finder
« on: February 16, 2009, 06:34:56 PM »
i have a edge finder i soldered a wire to and hooked to 5v then run another wire that clips to my work and is hooked to pin 12 on my bob right now i just have it set to trigger a estop when it touches how would be the correct way to hook it up and is their a plug in that i need to make it work? thanks

General Mach Discussion / Re: probing
« on: September 20, 2008, 09:02:03 PM »
thanks ill check them out

General Mach Discussion / probing
« on: September 20, 2008, 06:17:27 PM »
hi, iwas wanting to hook up an edge finder to tell mach 3 were edges are is thier any thing special i have to do to make it work  i have seen a couple video's on u tube but i did not know how to setit up and use it  with mach 3 thanks ben

General Mach Discussion / Re: can not calibrate axis
« on: September 08, 2008, 07:10:12 PM »
thank i got it going good today i cut two parts today and they were within .001" what i needed i changed my cnc4pc braekout board to a g100 i had. i guess it was just a bad new board. thanks ben

General Mach Discussion / Re: can not calibrate axis
« on: September 06, 2008, 07:40:19 AM »
thanks, i am going to change my breakout board and see what happens i have a g100 i bought when they first came out and never hooked it up the cnc4pc was easyer for me because there was more how to doc. it is on all axis just my y was the first that i noticed was not correct. i had a servo on my y axis when ii first noticed it i with steppers on the other 2 and thought it was just it because when i checked my axis and set them it was one inch  and everything checked out. till i went to start a project and my y axis over shot my work. i checked others at one inch and it was okay but when i checked other lenths on my x it was not okay. i did driver test again and it looks good.

Mach3 and G-Rex / g100 lic how to get
« on: September 04, 2008, 08:17:22 PM »
i have 2 g100 i have had them for awile i never could get them to work right so i just put them up i want to try them agian but the g100 downlad saysit is just trail how do ilicience it thanks

Pages: 1 2 »