Messages

1

Mach4 General Discussion / Re: New people welcome !! Come in here and introduce your self!

« on: May 16, 2009, 09:49:14 PM »

I'm kenton. I've been using a Taig 20i9 manual machine for three years creating jewelry, building & fixing anything! I missed it the day i sold it but due to a basement flood soaking my shop. With intention to rescue it,  I sold it to a good home. Now, all cleaned up,  I own a DSLS300/Mach3...first-time CNC'er. I completed all setups and connections but am without Mach 3 control of the servos. I'm troublreshooting as of this writing. -KPF

2

General Mach Discussion / servo control

« on: May 16, 2009, 08:01:36 PM »

All hardware and software installed, but no servo control from Mach3 to my DSLS 3000. I then enabled plug and play detection on the LPT1 but they only  "come to attention" and hold position. Tnere is no conflict on this port #1.  Any help appreciated, Thanks! PS... OS is XP Home