Hello Guest it is September 21, 2019, 10:56:09 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - didjado

Pages: 1
1
it has been there since day 1 .... but there was come problems with some of the switches and they got replaced( visible mechanical damage)  and the replacements look ok but there could be cable damage that is positional

2
they are on seperate lines ....

but the brain bit is over my head

3
it just can take a really long time to show the error... i never know if i have got the prob or not....sometime a whole day will go by no prob

4
General Mach Discussion / History log to diagnose limit switch prob
« on: May 19, 2009, 06:52:15 PM »
Hi All

i have a dodgy limit switch... but not to sure which one... the problem arrises once every 2-3 hours or so ... but some times can happen in 10 minutes......

the history screen only tells me tha it was a limit but not which one .....

any ideas

5
Feature Requests / standard views buttons on program tab
« on: May 15, 2009, 08:55:15 PM »
Hi

i would like to see for the tool path window a few standard view buttons.... like top side and front or even at minimum reset to top squared

6
that expains it ...

thanks

7
Hi

i cannot load the complete g code file into the demo version of mach3... the file originates from DeskProto software

and at  the below... stops loading
G1 X8.584 Y8.216 F700
G1 X8.805 Y7.995

about 1/10 of the file is being loaded

any ideas... the file is attached

Pages: 1