Hello Guest it is March 29, 2024, 10:37:22 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - i2bconcept

Pages: 1
1
Thank you for the reply Metalstech. I have plans to use these drives with smooth stepper. Can anybody recommend a motion controller capable to communicate with drives via Can BUS ? I think that this way the speed can be increased dramatically. Thank you guys.

2
Hi guys. I have the same drives on my 3 axis router. I have a question – what I will need to run my router with Mach.  Will I need a motion controller or some type of interconnect board? For now I have just 4 motors with AMC Digiflex drives and nothing else? Please help to the newbie  :)

Pages: 1