1
General Mach Discussion / Re: help with tool length offsets
« on: March 26, 2009, 04:24:02 PM »
Thanks,
so when I use g31 with my auto z probe 1st, that registers as tool 0?
If i try using g31 for say setting tool 6 later, that z height will then become the datum?
That might be where problems are arising.
Bill
so when I use g31 with my auto z probe 1st, that registers as tool 0?
If i try using g31 for say setting tool 6 later, that z height will then become the datum?
That might be where problems are arising.
Bill