Messages

1

Post Processors / Re: Here's Delcam Featurecam Mach3 Mill and Turn Post Processors

« on: January 22, 2014, 06:19:31 PM »

Thanks for the post.  FeatureCAM's example post was giving me fits with Mach.  Your post works great.

2

Galil / Re: Mach3 + Galil

« on: March 25, 2009, 03:22:44 PM »

Thanks, that's encouraging.  I'm somewhat early in the build process but I will try it out with my controller and let you know how it works out.  I think that the USB controller can still be placed inside of the control cabinet, I'll just need an extension cable with a bulkhead connector for the USB.  Let me know if you foresee any other issues.
Thanks again.

3

Galil / Re: Mach3 + Galil

« on: March 25, 2009, 01:41:47 PM »

Is the Galil DMC 2040 (USB) supported by this plugin?