Hello Guest it is December 03, 2021, 09:33:06 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - patternmaker

Pages: 1
1
General Mach Discussion / Re: MACH3 AND MASTERCAM5
« on: August 29, 2012, 04:29:28 PM »
thanks for the reply niclos,i have been using bobcadcam and mach3 as post processer, every thing works great.i have a demo of mastercam and noted it did not have mach3 in its system,when checking on the net users were not impressed when mach3 was used as post processer  in v5.I know that it works well with earlier mastercams, i was just trying to get feed back on how to load it into the mastercam post/machine  system.I can get mastercam to generate its g code and then save it to usb and then use my cnc router which has mach3 on it.just checking if others use it,thanks again for reply.

2
General Mach Discussion / MACH3 AND MASTERCAM5
« on: August 28, 2012, 08:29:28 AM »
HI ALL ,DO MACH3 AND MASTERCAM 5 WORK TOGETHER,ANY PROBLEMS?

Pages: 1