Hello Guest it is February 06, 2023, 05:18:44 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - 0009joe

Pages: 1
1
General Mach Discussion / Re: usb hand held keypad
« on: February 13, 2010, 10:18:16 AM »
Thanks for the input Tweakie. I have another question for you. Have you used it for anything besides moving the axis, such as changing the jogging speed or maybe an emergency stop? Is there anyway that you know of to assign functions to the other keys?

Thanks,

Joe

2
General Mach Discussion / usb hand held keypad
« on: February 10, 2010, 10:19:32 PM »
I am using a usb hand held keypad to set the x,y and z axis for g92 settings. My question is are there any possible catastophic glitches when using this keypad like maybe the z axis not responding and continuing into the material after the button is released. Using the keypad is very convenient compared to dragging around the keyboard.

Thanks,

Joe

3
General Mach Discussion / Re: Mach3 setup parallel port question- help
« on: September 12, 2009, 12:06:28 AM »
Hi, I'm having the same parallel port problems that you are. Did you install an add on port? if so how did it work out?

Thanks, New J

Pages: 1