Hello Guest it is March 28, 2024, 10:16:42 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - dmedlin1963

Pages: 1
1
Thanks for the info I'll move in that direction.

Dan

2
General Mach Discussion / Running Multiple Machines from One Computer
« on: April 18, 2012, 10:38:50 AM »
Is it possible to run multiple Mills and Lathes from one computer, from a software perspective. The hardware and cabling configurations aren't what I'm worried about. Would I just have differnet profiles or multiple copies of Mach3 for each machine.

I just don't have the room left in my shop for a computer, monitor, keyboard, pendant, mouse, etc. It would be less cluttered up with one rolling work station. The breakout boards and everything else are located inside of each machine's old controller box

Dan.  ???

3
General Mach Discussion / Ports & Pins, can they be Reset?
« on: April 01, 2012, 01:51:19 PM »
I'm seeing pins 1-11, 1-12, and 1-15 are active on the diagnostic screen, but there's nothing connected to them on my beakout board. Can pins be reset? Do I have a problem with the breakout board or with the printer port?

Dan

Pages: 1