Hello Guest it is April 13, 2024, 06:32:38 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - dmelacom

Pages: 1
Hello Guys

I'm new here. I'm hoping to learn how to convert my old lathe to run mach3 with new drives and such. it currently has an old bandit control
so the steppers and ball drives are all setup very nicely.

I'm going to start a new post asking for some hand holding as I can certainly gain much from what I've read on your forum.


Pages: 1