Hello Guest it is May 22, 2024, 07:55:54 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - deaf

Pages: 1
1
General Mach Discussion / setting up a bridgeport mill to cnc
« on: March 06, 2009, 11:30:07 PM »
hello everyone. I'm converting my bridgeport to cnc, it's an older J head. What is the easiest way to set it up, so when I turn it on, to send it to a home position everytime, same spot? Is this done with home switchs ? or a DRO slide mounted under the tables ?   Thanks

Pages: 1