Messages

1

General Mach Discussion / Re: Motor/screw configuration?

« on: March 01, 2009, 01:42:26 PM »

yes, thanks, I meant Y instead of A, thanks for the formula

2

General Mach Discussion / Re: Motor/screw configuration?

« on: March 01, 2009, 01:41:25 PM »

Thanks ger21. Is there a formula to arrive at those figures for future reference?

Also I'm using your touchscreen screen, very nice!

3

General Mach Discussion / Motor/screw configuration?

« on: March 01, 2009, 01:24:05 PM »

Hi All, I have my new router build done and am setting up Mach3. My steppers are turning using the G540 XML file. Every thing runs fine, I just need to figure my travel setting out.
Hopefully someone can help out.

specs:

Steppers are, Keling KL23H284-35-4B   387 oz-in
Controller is Geko G540
A and Y axis screw are McMasterCarr 5 Start ACME 2 turns for 1"
Z axis is THK KR33 ballscrew/actuator with 10mm per one turn.

My config is setup as inches.