Messages

1

General Mach Discussion / Re: Estop unable to reset

« on: February 11, 2013, 03:00:37 PM »

In config setup ports and pins make sure estop is enabled

2

General Mach Discussion / Re: Mill just wanders off

« on: March 08, 2009, 05:21:37 PM »

I had the same problem with my mill . It would run fine then for no reason it would just take off in a wrong direction. I fixed the problem I had to isolate my control boards power supply . You can disconect the ground wire , use a ups power supply or a isolation transformer. I used a isolation transfromer .

3

LazyCam (Beta) / Re: Important Tip For All Autocad Users

« on: March 01, 2009, 04:56:04 PM »

I use Autocad 2004 Lazycam loads all the 3 available dxf save formats . I have to use the drawing screen that comes up when Autocad starts up. I get no problems with the dxf's I save .When I load a template and do a drawing Lazycam will not load the dxf .
Hope this helps
Brian