Hello Guest it is March 28, 2024, 10:28:33 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Saturn06

Pages: 1
1
dspMC/IP Motion Controller / Bridgeport 300 retrofit using DSPMC
« on: November 22, 2010, 10:07:32 PM »
I am working on a Bridgeport Discovery 300 I had the spindle drive go out and could not get a replacement that would work with the old control. I installed a new spindle drive a control techniques SP1406 spindle drive. I had replaced two of the servo drives in the past and replaces the third during the retrofit with Servo Dynamics 1525 BR analog servo drives. I have done most of the rewiring and now are working the setup I am having problems with the servo drives if I power the servo drives with the the DSPMC controller turn off the motors do not move but with the controller turned on the motors turn about 20 rpm for about 2 sec. then the DSPMC e-stops and errors out need help.

2
Hi, My name is Randy. I live in northwestern Wisconsin

Just saying hello, I am in the process of building my own CNC plasma cutting table 4' by 4'  using four Gecko's G251, Keling Technology nema 23 KL23H286-20-8B steppers, rack and pinion and of course Mach 3.

I just bought a Bridgeport Discovery 300 SX 15 that I may convert to mach someday but for now just trying to get it running I plan on using to make parts for plasma build.

Pages: 1