Hello Guest it is December 01, 2021, 07:42:28 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - DanB

Pages: 1
1
General Mach Discussion / Re: Feedrate override wont work
« on: August 21, 2009, 05:06:54 PM »
i just changed the screenset and then it worked then switched it back and it still works.. pretty wierd but im happy it works now..

2
General Mach Discussion / Re: Feedrate override wont work
« on: August 21, 2009, 05:00:47 PM »
okay ill give that a try then will let u all know in 15 min :)

3
General Mach Discussion / Re: Feedrate override wont work
« on: August 21, 2009, 03:44:53 PM »
here are the files.. any other files would you need?

Thanks for your help

Cheers
Dan

4
General Mach Discussion / Re: Feedrate override wont work
« on: August 21, 2009, 03:24:20 PM »
R3.042.024
the no FRO on Que was unchecked and i did try check it and it didnt change anything..

its now back unchecked...

5
General Mach Discussion / Feedrate override wont work
« on: August 20, 2009, 10:37:44 PM »
I'm currently using CandCNC's screenset for plasma cutting and recently i needed to use the option Feedrate override and it wont work the percentage changes and the FRO number changed but the Unit/Min stayed the same and the cutting didnt go any faster..

any suggestion on how to enable it

Pages: 1